TC-LATTICE

TC-LATTICE adapter with 6-pin ribbon cable attached Lattice "Programming Cable" with TC-LATTICE adapter TC-Lattice with TC2030-IDC2 cable

(Adapter PCB only - Lattice HW-USBN-2B and Tag-Connect TC2030-IDC cable not included)

The TC-LATTICE Adapter allows users of Lattice's HW-USBN-2B Programming Cable to use Tag-Connect TC2030-IDC or TC2030-IDC-NL cable instead of the supplied flying lead solution for programming various Lattice Semiconductor devices.

The adapter has a 12-pin (2x6) 0.1" female header that plugs into the Lattice HW-USBN-2B programmer and supplies a 6-pin (2x3) 0.1" male box header suitable for use with Tag-Connect TC2030-IDC Plug-of-NailsTM Cables, eliminating the need for a physical connector on each and every target PCB.

By default, the TC-LATTICE adapter comes fitted with a 500 Ohm resistor connected between VCC and GND. This resolves the issue of the Lattice HW-USBN-2B unexpectedly raising VCC on low-power targets and eliminates the need for the resistor to be fitted to each of your target PCB's - see http://www.latticesemi.com/en/Support/AnswerDatabase/2/2/0/2205

TC2030 Pin Number Signal
 
1 VCC*
2 TMS
3 TDI/SI
4 TCK/SCLK
5 GND*
6 TDO/SO

* 500 Ohm Resistor fitted on back of Adapter PCB between VCC and GND

 

Price: $29.95