TC-XILINX6-M Xilinx 14-pin 2mm to 6-pin 0.1″ TC2030-IDC Adapter

$29.95

Adapter designed to be plugged into a Female 2mm 14-pin header found on programming cables for Xilinx such as Digilent JTAG-HS2 and Digilent JTAG-HS3. For use with TC2030‐IDC Plug-of-Nails™ cables.

AVAILABLE

SKU: TC-XILINX6-M Categories: , ,

Description

The TC-XILINX6-M is an adapter designed to be plugged into a Female 2mm 14-pin header found on programming cables for Xilinx such as Digilent JTAG-HS2, Digilent JTAG-HS2 and Digilent JTAG-HS3 and similar programmers.

Although primarily intended for use with our patented TC2030-IDC or TC2030-IDC-NL Plug‐of‐Nails™ Cables, this adapter may be useful to people wishing to use a 6‐pin 0.1” ribbon header on their PCB instead of the native 2mm 14-pin header.

For programmers such as Xilinx Platform Cable USB II DLC10 fitted with a male 14-pin header, see TC-XILINX6

Also see the similar TC2050-XILINX-M adapter solution that adapts to a 10-pin 0.1″ header for TC2050-IDC cables.

Note: Adapter only supplied, cable not included!

TC2030 Pin Number Signal
 
1 VREF*
2 TMS/SS/PROG
3 TDI/MOSI/DIN
4 TCK/SCLK/CCLK
5 GND*
6 TDO/MISO/DONE

This product is used in the following debugger/device solutions:

This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.

Digilent JTAG-HS2/HS3 for Xilinx using JTAG