TC-LATTICE

$29.95

Adapter allows users of Lattice’s HW-USBN-2B Programming Cable with Tag-Connect TC2030-IDC or TC2030-IDC-NL Plug-of-Nails™ cables for programming various Lattice Semiconductor devices.

AVAILABLE

SKU: TC-LATTICE Categories: , ,

Description

The TC-LATTICE Adapter allows users of Lattice’s HW-USBN-2B Programming Cable to use Tag-Connect TC2030-IDC or TC2030-IDC-NL cable instead of the supplied flying lead solution for programming various Lattice Semiconductor devices.

The adapter has a 12-pin (2×6) 0.1″ female header that plugs into the Lattice HW-USBN-2B programmer and supplies a 6-pin (2×3) 0.1″ male box header suitable for use with Tag-Connect TC2030-IDC Plug-of-Nails™ Cables, eliminating the need for a physical connector on each and every target PCB.

By default, the TC-LATTICE adapter comes fitted with a 500 Ohm resistor connected between VCC and GND. This resolves the issue of the Lattice HW-USBN-2B unexpectedly raising VCC on low-power targets and eliminates the need for the resistor to be fitted to each of your target PCB’s – see http://www.latticesemi.com/en/Support/AnswerDatabase/2/2/0/2205.

See also our TC-LATTICE-10 adapter for TC2050-IDC 10-pin target board connectors.

Note: Adapter only, Lattice HW-USBN-2B and Tag-Connect TC2030-IDC cable not included!

TC2030 Pin Number Signal
1 VCC*
2 TMS
3 TDI/SI
4 TCK/SCLK
5 GND*
6 TDO/SO

* 500 Ohm Resistor fitted on back of Adapter PCB between VCC and GND