TC-LATTICE
$29.95
Adapter allows users of Lattice’s HW-USBN-2B Programming Cable with Tag-Connect TC2030-IDC or TC2030-IDC-NL Plug-of-Nails™ cables for programming various Lattice Semiconductor devices.
AVAILABLE
Description
The TC-LATTICE Adapter allows users of Lattice’s HW-USBN-2B Programming Cable to use Tag-Connect TC2030-IDC or TC2030-IDC-NL cable instead of the supplied flying lead solution for programming various Lattice Semiconductor devices.
The adapter has a 12-pin (2×6) 0.1″ female header that plugs into the Lattice HW-USBN-2B programmer and supplies a 6-pin (2×3) 0.1″ male box header suitable for use with Tag-Connect TC2030-IDC Plug-of-Nails™ Cables, eliminating the need for a physical connector on each and every target PCB.
By default, the TC-LATTICE adapter comes fitted with a 500 Ohm resistor connected between VCC and GND. This resolves the issue of the Lattice HW-USBN-2B unexpectedly raising VCC on low-power targets and eliminates the need for the resistor to be fitted to each of your target PCB’s – see http://www.latticesemi.com/en/Support/AnswerDatabase/2/2/0/2205.
See also our TC-LATTICE-10 adapter for TC2050-IDC 10-pin target board connectors.
Note: Adapter only, Lattice HW-USBN-2B and Tag-Connect TC2030-IDC cable not included!
| TC2030 Pin Number | Signal |
|---|---|
| 1 | VCC* |
| 2 | TMS |
| 3 | TDI/SI |
| 4 | TCK/SCLK |
| 5 | GND* |
| 6 | TDO/SO |
* 500 Ohm Resistor fitted on back of Adapter PCB between VCC and GND
This product is used in the following debugger/device solutions:
This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.
Lattice HW-USBN-2B for Lattice using JTAG
