TC-LATTICE-10
$29.95
Adapter allows users of Lattice’s HW-USBN-2B Programming Cable with Tag-Connect TC2050-IDC or TC2050-IDC-NL Plug-of-Nails™ cables for programming various Lattice Semiconductor devices. Adapter only, cable not included.
AVAILABLE
Description
The TC-LATTICE-10 Adapter allows users of Lattice’s HW-USBN-2B Programming Cable to use Tag-Connect TC2050-IDC or TC2050-IDC-NL 10-pin cables instead of the supplied flying lead solution for programming various Lattice Semiconductor devices.
The adapter has a 12-pin (2×6) 0.1″ female header that plugs into the Lattice HW-USBN-2B programmer and supplies a 10-pin (2×5) 0.1″ male box header suitable for use with Tag-Connect TC2050-IDC Plug-of-Nails™ Cables, eliminating the need for a physical connector on each and every target PCB.
By default, the TC-LATTICE adapter comes fitted with a 500 Ohm resistor connected between VCC and GND. This resolves the issue of the Lattice HW-USBN-2B unexpectedly raising VCC on low-power targets and eliminates the need for the resistor to be fitted to each of your target PCB’s – see http://www.latticesemi.com/en/Support/AnswerDatabase/2/2/0/2205.
See also our TC-LATTICE adapter for even smaller TC2030-IDC 6-pin target board connectors.
Note: Adapter only, Lattice HW-USBN-2B and Tag-Connect TC2050-IDC-NL cable not included!
| TC2050 Pin Number | Signal |
|---|---|
| 1 | VCC* |
| 2 | TMS |
| 3 | GND* |
| 4 | TCK/SCLK |
| 5 | 5V OUT |
| 6 | TDO/SO |
| 7 | DONE |
| 8 | TDI/SI |
| 9 | TRST |
| 10 | ispEN/PROG/SN |
* 500 Ohm Resistor fitted on back of Adapter PCB between VCC and GND
This product is used in the following debugger/device solutions:
This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.
Lattice HW-USBN-2B for Lattice using JTAG, SPI/PDI/μPDI/aWire/debugWIRE
