TC2030-ICESPI Legged Cable for use with Atmel-ICE
For use with Atmel-ICE AVR this has a 6-pin TC2030 Legged Tag-Connector at one end and a 10-pin 0.05″ (1.27mm) pitch female IDC ribbon connector at the other.
The TC2030-ICESPI programming cable is a special cable for use with Atmel-ICE AVR that has a 6-pin TC2030 Legged Tag-Connector at one end and a 10-pin 0.05″ (1.27mm) pitch female IDC ribbon connector at the other. The 10-pin IDC can be plugged directly into Atmel-ICE providing 6-pin SPI, TPI, PDI, aWire and debugWIRE connections similar to the (now obsolete) Atmel AVR JTAGICE MkII.
Note: The 10-pin male connectors on the Atmel-ICE have reversed (non-standard) pin numbering. For Atmel-ICE you should purchase the LEMTA version of our cables which have the 10-pin ribbon connector fitted backwards which corrects for the Atmel-ICE pin numbering reversal. (Atmel ICE comes suppplied with a ribbon cable fitted with two 10-pin IDC connectors and a 6-pin single-in-line SIP connector – The 10-pin connector at the Atmel ICE end is reversed but the other is not, correcting the pin-numbering at the target PCB. Our LEMTA cables similarly have a reversed connector).
Note also that Atmel-ICE outputs the PDI and aWIRE DATA on a different pin to JTAGAVR MKII
|10-Pin IDC||LEMTA IDC||SPI||TPI||PDI||aWire||debugWIRE||6-pin TC2030|
Datasheet (for details of the TC2030 connector and footprint only)
This product is used in the following debugger/device solutions:
This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.
Atmel ICE for Atmel (Microchip) AVR using SPI/PDI/μPDI/aWire/debugWIRE