TC2030-PKT-ICESPI-NL 6-Pin Cable (no legs) for Microchip PICkit 4/5 & SNAP PDI/UPDI/aWire/debugWire/SPI/TPI

$43.00

6 pin no-legs plug-of-nails™ to Microchip PICkit 4/5 or SNAP programming/debugging cable with 8-pin SIP strip.
For AVR MCUs using SPI/TPI/PDI/UPDI/aWire/debugWire.
Note: For AVR processors – DOES NOT WORK WITH PIC MCU

AVAILABLE

SKU: TC2030-PKT-ICESPI-NL Categories: , ,

Description

Ideal for production programming of AVR MCUs using the Microchip PICkit 4/5 or SNAP in-circuit debuggers, the 6 pin plug-of-nails™ cable terminates in a 8 pin 0.1″ male SIP strip for connection to the debugger.  The target board pin connections on the plug-of-nails™ connector are the same as on our TC2030-ICESPI-NL cable. The cable supports programming via PDI, UPDI, aWire, debugWire, SPI or TDI.

For AVR processors – DOES NOT WORK WITH PIC MCU

The TC2030-PKT-ICESPI-NL is particularly suited to environments where the connection to the PCB is of short duration, and operators are working quickly from board to board.
A major advantage of the TC2030-PKT-ICESPI-NL is the extremely small footprint required on the PCB (hardly any bigger than a surface mount resistor) allowing the minimum possible space on your PCB to be used for the programming connection.
The TC2030-PKT-ICESPI-NL (no legs) cable is also compatible with the TC2030-PKT-ICESPI legged footprint allowing use of the TC2030-PKT-ICESPI legged cable for development work and TC2030-PKT-ICESPI-NL for fast programming in production.
The TC2030-PKT-ICESPI-NL is also suited to use for debugging and development when secured into position using a TC2030-CLIP board.

TC2030-PKT-ICESPI-NL Connections
8 Pin SIP SPI TPI UPDI PDI aWire debugWIRE 6-pin TC2030
1
2 VTG VTG VTG VTG VTG VTG 2
3 GND GND GND GND GND GND 6
4 MISO DAT PDI_DATA PDI_DATA DATA 1
5 SCK CLK 3
6 RST PDI_CLK RESET 5
7 MOSI 4
8

This product is used in the following debugger/device solutions:

This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.

Microchip PICkit 4/SNAP for Atmel (Microchip) AVR using SPI/PDI/μPDI/aWire/debugWIRE