Non-Slip Probe Tips

Non-slip probe tips in use

Non-slip Probe Tips - An Invaluable Addition to your Toolbox 

  • Probes slide onto standard 2mm multimeter probes
  • Tungsten-Carbide tips stay exactly where positioned - without slipping off!
  • Specially machined flutes bite through oxide, dirt, even coatings
  • Easily hold two probes in one hand without slipping
  • Safe to the touch
  • One pair of slide-on tips included*

*Main multimeter leads not included.

These non-slip probe tips make probing around a tightly packed circuit board a breeze. With these non-slip multimeter tips you no-longer have to worry about your probes slipping and sliding, shorting between tracks or just not penetrating through coatings. You can easily hold both probes in one hand whilst adjusting settings with the other hand.

Non-slip probe tips with multimeter probes

The Non-Slip Adapter has excellent ability to penetrate thin coatings and oxidation. Picture “A” shows the tip probing through a layer of enamel on a piece of transformer wire. The circuit board in “B” is intended for wet environments and has a coat of epoxy to seal the connections but the probe easily penetrates the coating. Solder joints and traces that have become oxidized can be dependably probed with the non-slip adapters as shown in “C”. The silkscreen on circuit boards that covers traces and interferes with standard probes can be probed through dependably.

Non-slip probe tips in use
Non-slip probe tips in use

The points have a steel shank with a tungsten carbide point that is configured as a 6 fluted inverted cone. 0.8mm tips are supplied.

Price: $29.95